Optimum Gloss-Coat Paint Coating 20 cc (New Version)

Free Bonus - purchase a tube of Gloss-Coat, and receive a 16"x16" CarPro microfiber suede leveling towel - valued at $2.79 - for free. 

Optimum Gloss-Coat provides better scratch and mar resistance, better UV resistance, better chemical etch resistance, and has better release properties than any other consumer product while providing unsurpassed gloss and slickness.

Additionally, you can top Optimum Gloss-Coat with any non-abrasive wax or sealant of your choice to add additional gloss and slickenss.

Features:

• Can be applied to all exterior surfaces (not recommended for glass)
• Semi-permanent protection (up to 3 years)
• The most advanced polymer system that forms a layer of clear coat over the automotive finishes
• Leaves the paint smooth and glossy
• Outstanding water beading behaviour
• Great chemical resistance 
• Made in USA

Kit Includes:

• (1) 20 cc Optimum Gloss-Coat (New Version)
• (1) Blue foam applicator pad
• (1) Blue syringe tip
• FREE BONUS - (1) 16"x16" CarPro microfiber suede towel 

Optimum Gloss-Coat can be used to protect the following surfaces:

• Painted surfaces
• Wheels 
• Plastic trim
• Bumpers 
• Aluminum & chrome surfaces

Aside: Since Optimum Gloss-Coat bonds to surfaces it is applied to, any paint imperfections must be removed before application. Also all waxes and oils must be removed from the surfaces for proper bonding.


Directions:

1. Polish paint to remove any defects. 
2. Clean surface with 15% IPA solution or CarPro Eraser to remove all polishing oils, waxes, and silicones.
3. Prime the applicator by making an X pattern across the pad. Only a few drops will be needed for each subsequent panel.
4. Wipe Optimum Gloss-Coat onto a single panel at a time in a thin layer using two directions, in a circular or front to back direction. 
5. Within 5 minutes, inspect the panel with adequate lighting looking for any thick areas that have not flashed away to clear. 
6. Use foam applicator or paint safe microfiber to even out any areas where you see streaks. This step is key, as any spots not leveled will have to be polished if allowed to cure. Panels will feel a bit tacky and will be self-leveling during cure time, so avoid any unnecessary touching, wiping, or contact to produce the best results.
7. Repeat steps1-6 for each panel where application is desired.

Not recommended for glass.